enkidec@enkidec.com Monza · Bozzolo, Italy Mon–Fri 8:00–18:00 CET
PFAS in industrial wastewater: how to design treatment without moving the problem – ENKIDEC cover
Key takeaways

A good PFAS design goes beyond "how much does it remove": it needs a characterisation plan, a mass balance, a comparison of barriers, residue management and acceptance KPIs agreed in advance. Removal is not destruction.

Characterise first

PFAS are a broad family whose presence varies with process, raw materials and washing. Define sampling points, frequency, method, target analytes and LOQs, and link results to process data. Flow matters: daily mass load shows the real size of the problem.

Know each barrier's limits

Activated carbon, ion-exchange resins, NF/RO membranes, foam fractionation and, in specific cases, destruction. Short- and ultrashort-chain compounds are harder. Adsorbents transfer PFAS to spent media and membranes concentrate them: the mass balance is the key check.

Ask suppliers for the right data

Breakthrough curves and spent volume for adsorbents; recovery, fouling, CIP, energy and concentrate composition for membranes; transformation products for destruction technologies.

Residues and tests

Spent carbon, resins, brines and sludge are part of the project. Bench tests with representative water, then a pilot where needed, with KPIs agreed upfront. See our PFAS treatment service.

Cristiana Ubezio
Cristiana Ubezio · Environmental engineer · Co-founder

Twenty years in water treatment, waste and biogas/biomethane: design, project management, site set-up, testing and commissioning.

LinkedIn

Follow ENKIDEC on LinkedIn

Weekly insights on regulation, technologies and real projects in water, wastewater and biomethane.

Follow on LinkedIn
Next step

Do you have a plant to design, permit or bring back to performance?

Tell us about it in a 30-minute call: we will tell you where to start, which data you need and which options to compare.